Four steps to solve the inverter overheating, no longer have to worry about the inverter jump over thermal protection friends Summer is the high frequency of the inverter overheating protection! Mainly poor heat (dust, fan failure, duct obstruction) lead to equipment downtime and delay production. It is recommended to carry out a simple maintenance of the inverter, blowing dust, repair fan, Shufeng Road, to ensure the normal operation of the equipment! If the inverter really overheating failure, but also do not need tension, we explain to you how to deal with the inverter in the operation of the overheating problem. First of all, you need to understand that the inverter itself through the sensor to detect the internal temperature of the machine, which is the same with our notebook thermal protection principle is the same, when the actual temperature is higher than the set value, it will issue an alarm signal to remind the user - "too hot You can not stand the ", while the inverter panel will show the corresponding overheating OH fault code. The process is also very simple! The first step: to confirm whether the cooling fan has been strike; run the fan should be turned. The second step: to confirm whether the blockage of the cooling duct, especially the inlet and outlet to focus on inspection, blocked can not. The third step: to confirm the surrounding ambient temperature, the general ambient temperature below 40 degrees Celsius for the normal range. Step 4: Of course, the above three steps are done or did not find the problem, but the work or overheating failure, then you still let the professional technical support engineers to help you solve.